Sizing and Decapping cases

                                          Dial caliper necessary for measuring case length

                                

  Sizing and Decapping Cases

 The first operation required after cleaning the cases is sizing.  That is required in order to hold the bullet as the case expands upon firing.  For handgun cases a tungsten carbide die is the best option. That eliminates the need for lubrication that you would need in a typical steel die. While the older steel dies are cheaper they are not as good an investment as the tungsten types which are made by all makers.  The sizing die also decaps the case meaning the old primer is knocked out. If you have cases that have Berdan primers, discard them. They have two off center holes which will break your decapping assembly. The Boxer primer has a center hole which is the better way to go. You will have some feel when sizing which is normal. If it is too easy or hard then you have a problem.  Too easy might mean a split case and too hard can mean that there is a smaller case inside or some dirt or a small pebble.

 

                                                                       45-70 Ammo

 Rifle cases are somewhat different in that there are no tungsten dies available for them. You need to lube the case body. Failure to do so will result in a case getting stuck in the die, requiring a difficult process to get the case out. Several makers make a stuck case remover kit to address that problem. There are various ways to lube including a lube pad or a paste. The body needs to be lubed but you don’t want to put too much around the neck and shoulder. If you do that you will have dents in the shoulder, which while not damaging look bad. In some instances you will have to disassemble the die and clean it out. The inside of the neck should be lubed with a dry lube so it is easier to pull the case out of the die. When you size a rifle case the neck is made too small and the neck expander brings the neck to the proper dimensions. There are several types of dies including neck sizing, full length and small base dies. The best option for typical reloading is the standard full length verity. Like the handgun dies you screw the sizing die down to touch the shell holder with the handle all the way down. Since rifle cases are larger and require more effort to size a larger press is desirable.

                                                    Favorite lube for rifle cases

 Rifle cases may stretch so it is necessary to check the length. Cases that are too long may be difficult to chamber and can cause high pressure and inconsistent ammo. What happens is the neck is shoved into the rifling which constricts it, causing these problems. You need a dial caliper or a case length gauge to check out the length. All of the reloading manuals give the proper length required for each round. If the length is ok you should chamfer the inside of the neck a little. That just cleans it a  little and may make it easier to seat the bullet. Just a little is enough. You can buy that tool as well as various case trimmers from different manufactures. For the case trimmer you will need to buy the correct collets and pilots.  All of this equipment is necessary to produce quality ammo

 

                                 Case Tumbler needed to clean your brass

Here is a u-tube video on sizing handgun cases. Much of that will apply to rifle brass.

http://www.youtube.com/watch?v=LeHaGT-vWkI&feature=youtu.be